The distance can be adjusted between 15 cm and 120 cm by a spindle trimmer. On the rear is a 4 mm threaded hole to install a clip. The PB-07 can then be installed on a mic - stand and will disappear behind the stand. The PB-07 can also be connected to a gooseneck microphone.The PB-07 works with 48 Volt phantom power to eliminate batteries and AC adaptors. Condenser microphones can also be used in connection with the PB-07.

 

Applications:

 

This model is able to disappear behind the mic stand. You can install it in a lower position on the stand and it will switch on the microphone, even though the singer is not exactly in front.

 

By eliminating unwanted background noise of other instruments into unused microphones on stage, the clarity of the mix and the dynamics will be increased due to less phase cancellation and background noise. It reduces the possibility of feedback from unused mics. Just plug & Play...

 

Specifications:

 

Physical Dimensions: 68mm length x 35mm height x 21mm width
Connectors: XLR 3-pin (1 = gnd, 2 = plus, 3 = minus)
Case construction: Aircraft-aluminium, black galvanized
Distance: Adjustable between 15 - 120 cm (depending of the type of reflection surface)
Angle: + / - 10 degrees
Switching noise: Immeasurable
Frequency response: 0 Hz - 22 kHz, - 3 dB in connection with 150 Ohm microphone impedance
Attenuation "mic on": 0 dB
Attenuation "mic off": 42 dB in connection with 150 Ohm microphone impedance
Usuable mic. types: All type of dynamic - and phantom powered mics. up to 5.5 mA current consumption
Maximum input level: 3 dB (1.1V)
Operating temperature: 0 - 55 degrees Celsius
Background light range: 0 - 20000 Lux daylight and 0 - 12000 Lux electric bulblight
Distance measurement: Active infrared reflection principle with 3 bit code
Power: 48 V Phantompower (passes phantompower to the microphone)
Current consumption: Ca. 3.8 mA

 

  manuals