AEA > AEA TRP2

AEA TRP2

Brand: AEA
The AEA TRP2 Ribbon Preamp provides two channels of high-output, high-impedance, and low-noise gain with a rich and natural sound that brings out the full potential of your microphones.
Specifically designed for ribbon microphones, the TRP2 excels at drawing out the warmth and lush sound that ribbons are uniquely known for.

TRP2 Preamp Overview


  • Two channels with 85dB of sweet and quiet JFET gain
  • Switchable phantom-power, polarity reverse, and high-pass filter
  • 63k ohm high-impedance circuitry providing better overall transients, frequency response, and higher output sensitivity
  • Optimized for ribbon mics, condensers, and dynamics
  • Switching power supply for easy use in any country
  • 1U half-rack with optional hardware for mounting one or two units together
  • Made in the U.S.A.

A Gain Powerhouse


The TRP2 is a powerhouse that provides unparalleled high gain with low-noise. With 85db of JFET output, the TRP2 gives you enough juice to record soft sources without ever having to worry about noise.

With the TRP2, you will never consider a source too quiet to record with a ribbon mic ever again. Passive ribbons with low output levels require preamps that supply a high level of output. If the preamp you use doesn’t have enough clean gain, the mic signal may seem too soft or noisy which may be apparent when recording quiet acoustic guitars or strings, especially at a distance or with long cable runs. The TRP2 eliminates this concern.


High Impedance Makes a Huge Difference


The sound and tonality of dynamic microphones like ribbons and moving-coils are directly affected by the impedance of a preamp. The higher the impedance, the better the sound. The RPQ2 boasts an extra high input impedance of 63K Ohms.

Preamps with an impedance of under 10k ohms will limit the lows, highs, and transients of your passive microphones. The RPQ2’s high impedance will reveal your microphone’s true nature– a thick low-end, open top-end, and articulate transient response that you will need to hear to believe. Both condensers and active microphones will also benefit from the RPQ2’s impedance.


AEA TRP2 Specifications.pdf

Pošljite povpraševanje

Polja označena z * so obvezna!