Maselec MPL-2 Peak & HF Limiter

Maselec MPL-2 Peak & HF Limiter

Brand: Maselec
The Maselec MPL-2 is a brick-wall and high frequency limiter that can be used to achieve high subjective levels and reduce unwanted high frequency levels (de-essing).
The Maselec MPL-2 is housed in a 1u 19" rack mount alloy case. A minimum of controls is used due to automatic time constants and optimisation techniques for the gain reduction. The advantage is not only simple operation but also increased performance for highly dynamic and inconsistent materials without the need for continuous readjustments.

The input gain does not reduce the wide dynamic range of the limiter. It can be used at its maximum setting with no increased risk of distortion. This eliminates the need for excessive levels, which could cause clipping in equipment feeding the input of the limiter. A further benefit is that the maximum peak output level (set with the threshold) is independent of different gain settings.

High frequency limiting is primarily intended for use as a de-esser, reducing unattractive high frequencies. Part of the high frequency limiter circuit is also used to reduce distortion from the wideband limiter.

Users of the MPL-2 will notice the removal of spurious peaks, and an increase of subjective levels, without the coloration and increased distortion so often associated with soft clippers and other ultra fast limiters.


Technical Specification


Input dynamic Range: Better than 115dB
Output dynamic range: 96dB to 115dB (depending on gain and threshold settings)
Maximum input level: 129dBu (balanced)
Maximum output level: 129dBu (balanced)
Distortion: Typically less than 0.003%
Limiter attack time: Instant
HF limiter attack time: Programme dependent  1msec to 20 msec
Release time: Programme dependent
Input impedance: 100k? ground floating electronically balanced
Output impedance: 34+34? electronically balanced
Threshold: +12dBu to +20dBu
H.F. Threshold: -14dBu to +20dBu
Gain: 0dB to 10dB
H.F. Limiter: >2kHz
Power: 90-130, 180-260 Volts @ 50-60 Hz
Fuse: 315mA, anti surge (slow)


Specification


MPL-2 Peak & HF Limiter Specification sheet.pdf

Pošljite povpraševanje

Polja označena z * so obvezna!